Types and installation requirements of seals in stainless steel piston rods

For the stainless steel piston rod, its sealing performance is still more useful, and most of them still use the pressure difference before and after sealing to achieve the sealing effect. If there is a gap in the packing seal, the gap is different in different parts. The notch gap should be used to compensate for the wear that occurs during the packing. It should control the pressure difference and the type of gas gap, and also meet some requirements. Only then will it help us complete our homework.

If conditions permit, we can also install a cylinder gasket, so that the stainless steel piston rod will not leak, and we can rest assured when using it, but it does not mean that we can completely relax, and we should pay attention to the places we need to pay attention to. The inspection of the stainless steel piston rod is not a simple process. We need to inspect a lot of parts, and only this can ensure our work goes smoothly. There is also a look at the choice of the piston and the cylinder liner in the piston rod, which involves a matching problem. When matching, we should clean all the parts, apply a layer of lubricating oil on the working surface, and then use it for work, but everyone must remember not to let the piston have too much clearance, Otherwise, our work may be affected. When the stainless steel piston rod is matched, pay attention to its strength. If the force is relatively tight when we are advancing, then it will be very laborious. If it is too loose, we need to re-fit the shape, so this strength we It should be mastered.

https://www.chennamachinery.com/